Cita:
Empezado por Pato-Patrol
When looking at the differences between aluminum and DOM links in the 4BLC you will have to set the wall thickness for 1/2 the outer diameter of the aluminum link to account for it being solid. A good starting point is 1.50" diameter solid for upper links, 1.75" diameter solid for lower front links and 2.00" diameter solid for the rear lower links. You will see that the FS in regards to bending and yield will be better with the aluminum links compared to DOM links so if you find you can't fit a large enough DOM link in your design to get the FS up where you want it you may try switching to a solid aluminum link.
 jajaja ...parece que tengo que traducirlo ....jejeje |
ahi dice clarito, espesor de pared de 1/2, no diámetro de barras...
Finalmente los links los dejaron tal cuál, nosostros seguimos discutiendo y el yip ya está en la calle! jajaajja
creo q ahora están modificando las torres de los COs pq son más largos q los amortiguadores q pusimos originalmente.
Varas mete la cuchara pa dar vuelta la página y ver avances
