Cita:
Empezado por Fantasma-4x4
Da lo mismo el material, en barra solida no tiene mucho sentido, estabas equivocado.
Slds.
|
When looking at the differences between aluminum and DOM links in the 4BLC you will have to set the wall thickness for 1/2 the outer diameter of the aluminum link to account for it being solid. A good starting point is 1.50" diameter solid for upper links, 1.75" diameter solid for lower front links and 2.00" diameter solid for the rear lower links. You will see that the FS in regards to bending and yield will be better with the aluminum links compared to DOM links so if you find you can't fit a large enough DOM link in your design to get the FS up where you want it you may try switching to a solid aluminum link.
jajaja ...parece que tengo que traducirlo ....jejeje