Cita:
Empezado por RoRRo_PeReZ
|
hay que colocar en ambas bandejas o no conseguiras nada, si adhieres a un solo lado cambia la geometria..
If spacers are added to the upper and lower control arms, theoretically the control arms should stay in the same geometry. Only the spindle would be moved. I have yet to dig too deep into this(mowing season started early in E. TN.) I'm hoping to get some alluminum blocks before too long. I have determined that some cutting will be needed to get spacers and longer bolts into the lower control arms. The only way to debunk the theories is to start wrenchin on it.
ojo que el que postea solo coloco un espaciadr arriba, lo cual no sirve para nada, ya que el que da la altura es la bandeja de abajo donde trabaja la barra de torsion
Saludos
Banana