Gonzalo,
mira lo que respondio el mismisimo "ZUK" :
I personally have not done it....no bearing conversion possible BUT if you could have a mild steel bushing machined up to press onto the existing Detroit and such that the bushing outside diameter will allow the V6 bearings to press on then you have done it. It is possible. Nobody sells the bushing YET....but it can be made....knowing the ID of the V6 bearing and the OD of the Detroit. It's just a simple sleeve. :)
Let me know how successful you are at this task.
Quien podra hacer esa pega??? en 4tec podran??? (yo no se que tan complicado sea eso, no siendo experto en el asunto se ve "facil")
Saludos,
|