Midiendo y midiendo estaria super al justo entre las cajas , en el caso de hacer una H debiera tener solo 40mm, muy poco y en el caso de otra cosa tengo 100mm entre plato y plato.
No descarto la idea de unirlas mediante un soporte que decia Rodrigo, para eso hay que usar alguna junta elastica de algo.
Leyendo el manual de instalaciond e la Klune V, ellos dejan la union a la caja de cambion con 1 solo cruzeta! no cacho.-
"Originally, the car had a short intermediate drive shaft running between the transmission and transfer case. What gets done here is to disassemble this shaft, and couple its original slip-yoke (from the transmission end of the shaft) directly to its flange, omittting the shaft part. This then slips into the rear of the tranny in the usual manner, and will bolt to a flange on the input side of the Klune-V."